Custom ATA shipping case configured for a Steadicam rig with the Transvideo monitor left attached, the Volt stabilization unit installed, and additional space reserved for a Hill B mount and small AKS. CNC-cut foam captures the sled, arm, monitor, and accessories in their working orientations so the operator does not have to disassemble and re-balance between locations.
Foam is relieved at the Volt motor housing, control board, and the Transvideo sun hood so finishes stay clean. Lid foam carries shock protection over the monitor face and the Hill B mount surface. injection-molded shell on a wheeled chassis with recessed latches.
Foam designed and CNC-cut in North Hollywood. Call 818-767-3030 to spec a build that adds a vest, transmitter pack, or a second monitor.
Specifications
- SKU:
- 9023-28
- Weight:
- 20.00 LBS
- Shipping:
- Calculated at Checkout
- Case Shell:
- Pelican Air 1615
- Gear:
- Monitor
- Fits Manufacturer:
- Steadicam
- Wheels / Handle:
- Yes
- Case Construction:
- Injection Molded
- Protection Rating:
- IP67 Waterproof
Will this fit my setup?
Tell us what you’re protecting and everything that travels with it. We check it against this build’s foam layout and reply with either a confirmation or the change we’d make. No obligation, and it goes to the people who cut the foam.
Got it — we’re checking your package.
We have your configuration and the exact build you were looking at. You’ll hear back with a fit confirmation or the modification we’d recommend.
My setup is different
Different body, extra accessories, an accessory that has to stay mounted, or dimensions that don’t exist yet. We modify an existing design or engineer a new one.
I need several
Repeatable foam layouts, consistent hardware, replacement foam and reorders against the same drawing. Standard practice for rental houses and studio fleets.
